![]() ![]() ![]() I was pretty sure I patched the Frequency Vectors correctly using freqVectorsEdit.sh, but apparently not, i've tried manually copy the plist from different imacs to the macpro 6,1 manually and with the freqVectorsEdit.sh but to no avail.Īny help at this point would be GREATLY appreciated You got to fix errors or things may not work properly. Like this: X86PlatformShim::start – Failed to send stepper. Backup the plist for your board-id and replace it with a different plist.Ĥ.) If you use ssdtPRGen.sh to generate your ssdt_pr.aml then make sure to use the -turbo argument for overclocked setups.ĥ.) Check for XCPM related errors at boot time. Please use one that works for your setup.ģ.) If sysctl -n _loaded_count returns 0 then the FrequencyVectors data is not being used. You may still use AppleIntelCPUPowerManagement.kext Even when X86PlatformShim.kext is loaded.Ģ.) The FrequencyVectors data in the plist is used to configure power management, and is not the same for all models/board-ids. This however is not enough to enable XCPM mode. Sysctl -n _loaded_count = 0ġ.) The X86PlatformPlugin.kext will only load with the plugin-type property is set on the first logical CPU. IA32_TSC_DEADLINE.(0圆E0) : 0x7F190854989ĬPU Maximum Efficiency Ratio.: 1200 MHzĬPU Maximum non-Turbo Frequency.: 3400 MHzĬPU Maximum Turbo Frequency.: 3800 MHzĬist and current ssdt.aml attached Power Policy Preference.: 0 (highest performance) Enhanced Intel SpeedStep Technology : 1 (enabled) ![]() : 0 (C-States not included, I/O MWAIT redirection not enabled) ![]() Then ran AppleIntelInfo and get the following output:ĪppleIntelInfo.kext v1.6 Copyright © 2012-2016 Pike R. I've generated a ssdt.aml and placed in ACPI/patched folder using ssdtPRGen.sh So i am having some problems with my install Sierra PB7, I've managed to get the xcpm patches working (Credit © pikeralpha © okrasit) only by using fakeCPUID 0x040674, I've read a lot of people being able to get the patches working without having a fakeCPUID, so i'm at a bit of a loss here. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |